Submitted by bluee on Sat, 11/05/2022 - 22:03
t1000s led controller
Maximal LEDs per Port


The SD card in controller can not be hot-swappable, plug the SD card every time, you must first disconnect the power supply

t1000s sd card led pixel controller software

You can program t1000s with lededit software check tutorial here



Question 1:

After power, the T-1000S ERROR indicator has been flashing without display output


The ERROR indicator flashing means the controller did not read the card correctly, possible problems: ② SD card is empty, with no effect file. ②The effect file in the SD card and the controller model do not match, please choose correct controller model in LedEdit and then re-create the effect file *led. ③SD card is not formatted to FAT before copying effect files. ④Please check the supply power voltage, the controller can be individually powered to exclude power reasons ⑤Change the SD card and then test to exclude the possibility of a bad SD card

Question 2:

The controller is powered on, the indicator is normal, but no effect change in lighting


The reasons for this are as follows: ① Check if the lighting′s signal line and the controller are connected correctly ② If the TTL signal is received, the lamp and the controller must be common ground, that means connect the lighting′s and the controller′s ground together ③ Check if the model chosen during creating display files on the SD card match the chips used in the lighting